FAQ
- Q: How can I make an order?
A: Pls kindly confirm the product, qty, and your address and payment terms. Once financial dept. Receive it, we will send out asap, usually within 2 days. Large qty might need 1 week time depending on whether it is peak time.
- Q: The fan of dry type acrylic bender turns on until the machine Gets to certain Temperature❓
A: Or does the fan should turn on at the same time that the machine is turned on.
Because it's been 20 minutes and the fan haven't turned on still we are frighten that the machine would over heat.
It is to automatically turn on the fan. There is a switch below, you can choose between forced and automatic. There is a small yellow dot on the back of the machine. Pressing it is automatic, and pressing it again is mandatory. Normally, it reaches 50 degrees, and the fan starts to turn automatically. The poTrend consumption of the whole machine does not exceed 800W, and the general conversion plug can be used. The customer can install the plug with his own needs.
- Q: The reason for plastic edges damages of large format acrylic bender estimated be high temperature
A: Solutions are as following:
a) Change it.
b) Avoid too high water and machine working temperature.
c) Use bigger water bucket.
d) When long time work or lots of work, can put some ice into water bucket for cooling.
- Q: Is ther a need to order more heating wire for acrylic bending tools and machines?
A: No, our acrylic bending products can work many years without any problem. Besides there usually is 1 extra pc wire as accessory in the complete set. If you plan to order it, we sure can offer you with best price.
- Q: Can I use two acrylic bending machines at same time, which adopt water cooling system, and connect water pump together?
A: We would not suggest such method. It is better connect machine body and its water pump , not with another machine’s together.
- Q: What is the package?
A: All products in carton. If wooden cases needed, we will also make it. Pls kindly wooden cases need more time.
- Q: Shall we make delivery term FOB Shanghai?
A: Sure. Available delivery term:EXW, FOB and CFR. In addition, by sea or by air both ok. Small qty by international express would be fine.
- Q: What's the working theory of acrylic bending machine?
A: Softening and bending of plastic plate by far Infrared ray.
- Q: How is the acrylic bending machine heated?
A: Quartz tube, infrared heating.
- Q: Do you have the bigger one?
A: Only two models at present
700mm: applicable length≤650mm
1300mm: applicable length≤1250mm